Juniper J-Series Administration Manual page 309

Minimum Rtt: 1093 usec, Maximum Rtt: 1372 usec, Average Rtt: 1231 usec,
Jitter Rtt: 279 usec, Stddev Rtt: 114 usec
Probes sent: 3, Probes received: 3, Loss percentage: 0
Owner: Rpm-Bgp-Owner, Test: Rpm-Bgp-Test-1
Target address: 10.209.152.37, Probe type: icmp-ping, Test size: 5 probes
Routing Instance Name: LR1/RI1
Probe results:
Response received, Fri Oct 28 05:20:23 2005
Rtt: 662 usec
Results over current test:
Probes sent: 5, Probes received: 5, Loss percentage: 0
Measurement: Round trip time
Minimum: 529 usec, Maximum: 662 usec, Average: 585 usec,
Jitter: 133 usec, Stddev: 53 usec
Results over all tests:
Probes sent: 5, Probes received: 5, Loss percentage: 0
Measurement: Round trip time
Minimum: 529 usec, Maximum: 662 usec, Average: 585 usec,
Jitter: 133 usec, Stddev: 53 usec
The output shows the probe results for the RPM tests configured on the Services
Meaning
Router. Verify the following information:
Each configured test is displayed. Results are displayed in alphabetical order,
sorted first by owner name and then by test name.
The round-trip times fall within the expected values for the particular test. The
minimum round-trip time is displayed as
time is displayed as
as
Average Rtt
A high average round-trip time might mean that performances problems exist
within the network. A high maximum round-trip time might result in high jitter
values.
The egress (outbound) trip times fall within the expected values for the particular
test. The minimum outbound time is displayed as
maximum outbound time is displayed as
outbound time is displayed as
The ingress (inbound) trip times fall within the expected values for the particular
test. The minimum inbound time is displayed as
maximum inbound time is displayed as
inbound time is displayed as
The number of probes sent and received is expected.
Lost probes might indicate packet loss through the network. Packet losses can
occur if the remote server is flapping. If the RPM probe type is TCP or UDP,
complete probe loss might indicate a mismatch in TCP or UDP RPM port number.
For Type
For a complete description of
Related Topics
System Basics and Services Command Reference.
, and the average round-trip time is displayed
Maximum Rtt
.
Average egress time
Average ingress time
, each peer is configured as the correct type (either internal or external).
show services rpm probe-results
Chapter 14: Configuring RPM Probes
, the maximum round-trip
Minimum Rtt
Minimum egress time
, and the average
Maximum egress time
.
Minimum ingress time
Maximum ingress time , and the average
.
output, see the JUNOS
Verifying RPM Statistics
, the
, the
287