Juniper J-Series Administration Manual page 300

J-series Services Router Administration Guide
Table 141: Configuring Basic RPM Probes (continued)
Task
Configure the RPM test
icmp-test
RPM owner customerA .
The sample RPM test is an ICMP probe
with a test interval (probe frequency) of
15 seconds, a probe type of
icmp-ping-timestamp , a probe timestamp,
and a target address of 192.178.16.5
Configure RPM thresholds and
corresponding SNMP traps to catch
ingress (inbound) times greater than
3000 microseconds.
278
Configuring RPM with a Configuration Editor
J-Web Configuration Editor
for the 1. On the Rpm page, select
customerA.
2. In the Test box, click Add new
entry
3.
In the Name box, type
4.
In the Test interval box, type
.
5. In the Probe type box, select
icmp-ping-timestamp.
6. Select the Hardware timestamp
check box.
7. In the Target box, select the Yes
check box, and click Configure.
8. In the Target type box, select
Address.
9. In the Address box, type
192.178.16.5 .
10. Click OK.
1. On the Probe page, select
icmp-test.
2. In the Thresholds box, select the
Yes check box, and click
Configure.
3. In the Ingress time box, type
4. Click OK.
5. In the Traps box, click Add new
entry.
6. In the Value box, select
ingress-time-exceeded.
7. Click OK.
CLI Configuration Editor
1. From the
[edit]
edit services rpm probe customerA
2. Enter
icmp-test .
set test icmp-test probe-frequency 15
15 .
3. Enter
set test icmp-test probe-type
icmp-ping-timestamp
4. Enter
set test icmp-test
hardware-timestamp
5. Enter
set test icmp-test target address
192.178.16.5
1. Enter
set probe customerA test icmp-test
thresholds ingress-time 3000
2. Enter
.
3000
set probe customerA test icmp-test
traps ingress-time-exceeded
hierarchy level, enter