Juniper J-Series Administration Manual page 68

J-series Services Router Administration Guide
For a complete description of
Related Topics
Interfaces Command Reference.
46
Verifying Dialer Interface Configuration
The physical interface is
Enabled
of the following:
In the CLI configuration editor, delete the
interfaces interface-name]
In the J-Web configuration editor, clear the Disable check box on the
Interfaces>interface-name page.
The physical link is . A link state of
Up
module, interface port, or physical connection (link-layer errors).
The Last Flapped time is an expected value. The
last time the physical interface became unavailable and then available again.
Unexpected flapping indicates possible link-layer errors.
The traffic statistics reflect expected input and output rates. Verify that the
number of inbound and outbound bytes and packets matches expected
throughput for the physical interface. To clear the statistics and see only new
changes, use the
clear interfaces statistics interface-name
The dialer state is Active when a USB modem call is in progress.
The LCP state is when a USB modem call is in progress. An LCP state of
Opened
Closed or Not Configured indicates a problem with the dialer configuration that
needs to be debugged with the
For information about the
Command" on page 246.
. If the interface is shown as
disable
level of the configuration hierarchy.
indicates a problem with the interface
Down
Last Flapped
monitor traffic interface interface-name
monitor traffic command, see "Using the monitor traffic
show interfaces dl0 extensive
, do either
Disabled
statement at the [edit
time indicates the
command.
command.
output, see the JUNOS