Monitoring Dlsw Routing Information - Juniper J-Series Administration Manual

Table 55: Summary of Key RIP Routing Output Fields (continued)
Field Values
Routes Number of RIP routes advertised on the logical
advertised interface.
RIP Neighbors
Neighbor Name of the RIP neighbor.
State State of the RIP connection:
Source Local source address.
Address
Destination Destination address.
Address
In Met Value of the incoming metric configured for the RIP
neighbor.

Monitoring DLSw Routing Information

To view DLSw routing information, select Monitor>Routing>DLSw Information,
or enter the following CLI commands:
Table 56 on page 121 summarizes key routing information output fields in the DLSw
routing display.
Table 56: Summary of Key DLSw Routing Information Output Fields
Field Values
DLSw Capabilities
Peer IP address of the peer DLSw router
Vendor ID Numerical value assigned to Juniper Networks.
or (Down).
Up Dn
show dlsw capabilities
show dlsw circuits
show dlsw peers
show dlsw reachability
Chapter 7: Monitoring the Router and Routing Operations
Additional Information
This value is the name of the interface on which RIP
is enabled. The name is set in either of the following
ways:
In the J-Web configuration editor, on the
Protocols>RIP>Group> group-name>Neighbor
page
In the CLI configuration editor, with the
statement at the
neighbor-name
level of the configuration
group group-name]
hierarchy
This value is the configured address of the interface on
which RIP is enabled.
This value is the configured address of the immediate
RIP adjacency.
Additional Information
Using the Monitoring Tools
neighbor
[edit protocols rip
121