Mazda CX-7 2007 Workshop Manual page 1047

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
8. Using a plastic hammer, tap the control valve
body cover to remove it.
Caution
• Be careful not to damage the solenoid
valves and connectors.
• Do not pull the wiring harnesses when
removing the connector.
Note
• Disconnect the solenoid connector
according to the following procedure:
1. Insert a precision screwdriver from the
backside into the connector as shown in
the figure.
2. Pry the screwdriver in the direction of the
arrow and disconnect the connector.
Caution
• Do not damage the solenoid valves and
connectors with the screwdriver.
• When disconnecting connectors, grasp
the connectors, not the harnesses.
Otherwise, the harnesses may be pulled
out of the connector causing poor
contact.
9. Disconnect the solenoid connectors, VSS
connector and the input/turbine speed sensor
connector.
10. Disconnect the coupler component from the
clamp.
CLAMP
acxuuw00000586
05-17
acxuuw00000587
acxuuw00000588
CLAMP
acxuuw00000589
05-17–39