Mazda CX-7 2007 Workshop Manual page 1066

AUTOMATIC TRANSAXLE SHIFT MECHANISM
8. Insert the a 1.5mm {0.059 in} round bar or similar
into hole A with the slider pin fully pushed in.
9. Fully pull the end of the interlock cable.
10. Push the a 1.5mm {0.059 in} round bar or similar
into hole B and hole C of the lock unit until it
passes through.
11. Disconnect the brake switch connector.
12. Remove the brake switch. (See04-11-6 BRAKE
PEDAL REMOVAL/INSTALLATION.)
13. Install a new brake switch. (See04-11-6 BRAKE
PEDAL REMOVAL/INSTALLATION.)
Caution
• Do not connect the brake switch
connector until the interlock cable
adjustment is completed.
14. Install the lock unit to the bracket. (See05-18-10 Interlock Cable Installation Note.)
15. Rotate the slider pin to release the lock and verify that it slides freely.
16. Verify that the slider pin contacts the brake pedal
stopper rubber and rotate the slider pin to lock.
05-18–4
LOCK UNIT
B
A
SLIDER PIN
LOCK UNIT
B
A
SLIDER PIN
UNLOCK
LOCK
MARKING
SLIDER PIN
INTERLOCK
CABLE
C
BRAKE SWITCH
acxuuw00000407
INTERLOCK CABLE
acxuuw00000408
INTERLOCK
CABLE
C
BRAKE SWITCH
acxuuw00000407
acxuuw00000409