Mazda CX-7 2007 Workshop Manual page 1206

DTC DISPLAY
1. Connect the M-MDS to the DLC-2 connector.
2. After the vehicle is identified, select the following
items from the initialization screen of the M-MDS.
• When using the IDS (notebook PC)
— Select the "Toolbox" tab.
— Select "Self Test".
— Select "Module".
— Select "RCM".
• When using the PDS (pocket PC)
— Select "Module Tests".
— Select "RCM".
— Select "Self Test".
3. Verify the DTC according to the directions on the
screen.
• If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
4. After completion of repairs, clear all DTCs stored in the SAS control module. (See 08-02-4 CLEARING DTC.)
End Of Sie
CLEARING DTC
1. Connect the M-MDS to the DLC-2 connector.
2. After the vehicle is identified, select the following
items from the initialization screen of the M-MDS.
• When using the IDS (notebook PC)
— Select the "Toolbox" tab.
— Select "Self Test".
— Select "Module".
— Select "RCM".
• When using the PDS (pocket PC)
— Select "Module Tests".
— Select "RCM".
— Select "Self Test".
3. Verify the DTC according to the directions on the
screen.
4. Press the clear button on the DTC screen to clear the DTC.
5. Verify that no DTCs are displayed.
End Of Sie
DTC TABLE
• DTCs are common for present and past malfunction diagnosis.
Note
• When DTCs not shown in the DTC table are displayed, replace the SAS control module.
• If the air bag system warning light does not illuminate or remains illuminated when the ignition switch is
turned to the ON position, inspect and repair the air bag system warning light circuit, and then confirm that
the air bag system warning light is operational.
• The air bag system warning light flashes the DTC pattern for five cycles, and then remains illuminated
until the ignition switch is turned to the ACC or LOCK position.
Air bag system warning light
M-MDS
display
Flashing pattern
B1013 16
B1017 59
B1144
45
B1145
08-02–4
ON-BOARD DIAGNOSTIC
DTC
DLC-2
DLC-2
System malfunction location
Priority
ranking
Seat weight sensor calibration
21
error
Deployment prohibited because
4
configuration is not set
Driver-side side air bag sensor
No.2 system internal circuit
disabled
11
Driver-side side air bag sensor
No.2 system communication error
id080200800400
acxuuw00001023
id080200800500
acxuuw00001023
id080200800600
Page
(See 08-02-10
DTC B1013)
(See 08-02-11
DTC B1017)
(See 08-02-12
DTC B1144,
B1145)