Mazda CX-7 2007 Workshop Manual page 1060

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
4. Squeeze the header tabs down in the order as
shown against the lip of the radiator outer tank
base with the locking-type pliers while rotating the
pliers toward the tank.
5. Verify that the height of the header tabs is same
as the height before removal.
6. Inspect for leakage from radiator. (See 01-12-6
ENGINE COOLANT LEAKAGE INSPECTION[L3
WITH TC].)
End Of Sie
WM: DRIVE PLATE
DRIVE PLATE REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL]
1. Remove the transaxle. (See05-17-29 AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION[AW6A-EL,
AW6AX-EL].)
2. Remove in the order indicated in the figure.
1 Drive plate mounting bolts
(See05-17-53 Drive Plate Mounting Bolts Removal
Note.)
2 Backing plate
3 Drive plate
(See05-17-53 Drive Plate Installation Note.)
3. Install in the reverse order of removal.
05-17–52
6
3
8
O-RING
SST
108—116
{11.0—11.8, 79.7—85.5}
R
RADIATOR LOWER
TANK
LOCKING TYPE
PLIERS
4
5
acxuuw00002301
RADIATOR
LOWER
TANK
HEADER TAB
HEIGHT
acxuuw00002297
id051723802500
3
N·m {kgf·m, ft·lbf}
acxuuw00000611