Mazda CX-7 2007 Workshop Manual page 1281

5. Connect the SST (Deployment tool) to the SST
(Adapter harness).
6. Connect the SST (Deployment tool) to the
battery. Connect the power supply red clip to the
positive battery terminal, and the black clip to the
negative battery terminal.
7. Verify that the red lamp on the SST (Deployment
tool) is illuminated.
8. Verify that all persons are standing at least 6 m
{20 ft} away from the vehicle.
9. Press the activation switch on the SST
(Deployment tool) to operate (deploy) the curtain
air bag module.
10. Disconnect the SSTs (Deployment tool) from the
SSTs (Adapter harness).
Pre-tensioner Seat Belt
1. Remove the B-pillar lower trim.
(See 09-17-16 B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
2. Remove the pre-tensioner seat belt and connect
the SST (Adapter harness) as shown in the
figure. (See 08-11-2 FRONT SEAT BELT
REMOVAL/INSTALLATION.)
3. Install the pre-tensioner seat belt.
4. Connect the SST (Deployment tool) to the SST
(Adapter harness).
5. Connect the SST (Deployment tool) to the
battery. Connect the power supply red clip to the
positive battery terminal, and the black clip to the
negative battery terminal.
6. Verify that the red lamp on the SST (Deployment
tool) is illuminated.
7. Verify that all persons are standing at least 6 m
{20 ft} away from the vehicle.
AIR BAG SYSTEM
49 H066 002
49 H066 002
49 H066 002
49 L066 002
49 L066 002
acxuuw00001272
ACTIVATION
SWITCH
acxuuw00001267
08-10
acxuuw00001273
49 L066 002
acxuuw00001272
08-10–21