Mazda CX-7 2007 Workshop Manual page 1052

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
7. Install the TFT sensor with the lock plate and a
bolt to the control valve body component as
shown in the figure.
Tightening torque
8— 12 N·m {82— 122 kgf·cm, 72— 105 in·lbf}
8. Connect the solenoid connectors, VSS connector
and the input/turbine speed sensor connector.
9. Connect the coupler component to the clamps.
Note
• Completely remove sealant and oil with
white gasoline or similar.
10. Clean sealant and oil off the contact surface of
the transaxle case with the control valve body
cover and the bolt holes.
Note
• Completely remove oil with white gasoline or
similar.
11. Clean oil off the contact surface of the new control
valve body cover with the transaxle case.
05-17–44
CLAMP
acxuuw00000601
CLAMP
acxuuw00000589
acxuuw00000602