Mazda CX-7 2007 Workshop Manual page 1382

2007 mazda cx-7
Hide thumbs Also See for CX-7 2007:
Table of Contents

Advertisement

DTC B2721[BCM]
DTC B2721
Liftgate ajar output short to ground
DETECTION
Short to GND in wiring harness between BCM and liftgate latch switch
CONDITION
• Short to GND in wiring harness between BCM terminal 5P and liftgate latch switch terminal B
POSSIBLE
• Liftgate latch switch malfunction
CAUSE
• BCM malfunction
LIFTGATE LATCH SWITCH WIRING
HARNESS-SIDE CONNECTOR
Diagnostic procedure
STEP
1
INSPECT LIFTGATE LATCH SWITCH
CONNECTOR
• Disconnect the liftgate latch switch
connector.
• Inspect the liftgate latch switch connector
terminals for poor connection (such as
damaged/pulled-out pins, and corrosion).
• Is there any malfunction?
2
INSPECT BCM CONNECTOR
• Disconnect the BCM connector.
• Inspect the BCM connector terminals for
poor connection (such as damaged/pulled-
out pins, and corrosion).
• Is there any malfunction?
3
INSPECT LIFTGATE LATCH SWITCH SIGNAL
CIRCUIT FOR SHORT TO GND
• Inspect for continuity between BCM terminal
5P (wiring harness-side) and body GND.
• Is there continuity?
4
INSPECT LIFTGATE LATCH SWITCH
• Inspect the liftgate latch switch.
(See 09-14-10 LIFTGATE LATCH SWITCH
INSPECTION.)
• Is there any malfunction?
5
VERIFY TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear the DTC from the BCM memory using
the M-MDS.
• Perform the self-test.
(See 09-02F-26 BCM SELF-TEST[BCM].)
• Is the same DTC present?
End Of Sie
09-02F–20
ON-BOARD DIAGNOSTIC [BCM]
LIFTGATE LATCH
SWITCH
B
A
INSPECTION
BCM
5P
BCM WIRING HARNESS-SIDE
CONNECTOR
5AB
5Y
5V
5S
5P 5M
5J
5AC
5Z
5W
5T
5Q
5N
5K
5AD
5AA
5X
5U
5R
5O
Yes
Repair or replace the terminal, then go to Step 5.
No
Go to the next step.
Yes
Repair or replace the terminal, then go to Step 5.
No
Go to the next step.
Yes
Repair or replace the wiring harness for a possible short to
GND, then go to Step 5.
No
Go to the next step.
Yes
Replace the liftgate latch switch, then go to the next step.
(See 09-14-10 LIFTGATE LATCH AND LOCK ACTUATOR
REMOVAL/INSTALLATION.)
No
Go to the next step.
Yes
Replace the BCM.
(See 09-40-1 BODY CONTROL MODULE (BCM)
REMOVAL/INSTALLATION.)
No
DTC troubleshooting completed.
id0902f5833300
5G
5D 5A
5H
5E
5B
5L
5I
5F
5C
ACTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents