Mazda CX-7 2007 Workshop Manual page 1037

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
5. Using the SST and a hammer, tap a new oil seal
so that the specified oil seal position is obtained.
Substitution SST
• 49 F026 102
Outer diameter: 27 mm {1.06 in} or more
Inner diameter: 15— 18 mm {0.60— 0.70 in}
6. Install the TCM. (See 05-17-25 TCM REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
7. Install the air cleaner component. (See 01-13-5
INTAKE AIR SYSTEM REMOVAL/
INSTALLATION[L3 WITH TC].)
8. Connect the negative battery cable.
End Of Sie
AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL]
1. Disconnect the negative battery cable.
2. Remove the following parts.
(1) Battery and battery tray (See 01-17-2 BATTERY REMOVAL/INSTALLATION[L3 WITH TC].)
(2) Air cleaner component (See 01-13-5 INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH TC].)
(3) Engine cover
(4) Charge air cooler (See 01-13-5 INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH TC])
(5) Windshield wiper arm and blade (See 09-19-3 WINDSHIELD WIPER ARM AND BLADE REMOVAL/
INSTALLATION.)
(6) Cowl grille (See 09-16-11 COWL GRILLE REMOVAL/INSTALLATION.)
(7) Front wheel
(8) Splash shield
(9) Under cover
(10)Side cover
(11)Propeller shaft (transfer side) (See 03-15-3 PROPELLER SHAFT REMOVAL/INSTALLATION.)
(12)Transfer oil cooler (See 03-16-3 TRANSFER OIL COOLER REMOVAL/INSTALLATION.)
3. Drain the ATF. (See 05-17-11 AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT[AW6A-EL, AW6AX-
EL].)
Warning
• Improperly jacking a transaxle is dangerous. It can slip off the jack and may cause serious injury.
Caution
• To prevent the torque converter and transaxle from separating, remove the transaxle without
tilting it toward the torque converter.
4. Remove in the order shown in the figure.
5. Install in the reverse order of removal.
6. Add ATF to the specified level. (See 05-17-11 AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT[AW6A-EL, AW6AX-EL].)
7. Perform the mechanical system test. (See 05-17-3 MECHANICAL SYSTEM TEST[AW6A-EL, AW6AX-EL].)
Service item
Line pressure test
ATX replacement
ATX overhaul
Torque converter
replacement
Oil pump replacement
Control valve body
component
Clutch system
replacement
X : Test to be performed after the service work
Stall test
X
X X
X X
X
X
X
-0.3—0.4 mm
{-0.0118—0.0157 in}
Test item
Time lag test
X
X
49 G030 797
49 F026 102
acxuuw00000534
id051723802400
05-17
Time lag test
X
X
05-17–29