Mazda CX-7 2007 Workshop Manual page 1290

5. Secure the tires with wire.
6. Connect the SST (Deployment tool) to the SST
(Adapter harness).
7. Connect the SST (Deployment tool) to the
battery. Connect the power supply red clip to the
positive battery terminal, and the black clip to the
negative battery terminal.
8. Verify that the red lamp on the SST (Deployment
tool) is illuminated.
9. Verify that all persons are standing at least 6 m
{20 ft} away from the vehicle.
10. Press the activation switch on the SST
(Deployment tool) to operate (deploy) the pre-
tensioner seat belt.
11. Disconnect the SSTs (Deployment tool) from the
SSTs (Adapter harness).
End Of Sie
AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DISPOSAL PROCEDURES
Warning
• A live (undeployed) air bag module or pre-tensioner seat belt may accidentally operate (deploy)
when it is disposed of and cause serious injury. Always refer to the "AIR BAG MODULE AND PRE-
TENSIONER SEAT BELT DEPLOYMENT PROCEDURES" and dispose of air bag modules and pre-
tensioner seat belts in a deployed condition.
• The air bag modules and the pre-tensioner seat belts are very hot immediately after they are
deployed. You can be burned. Do not touch an air bag module and pre-tensioner seat belt for at
least 15 min after deployment.
• Pouring water on the deployed air bag module and pre-tensioner seat belt is dangerous. The water
will mix with the residual gases to form a gas that can make breathing difficult. Do not pour water
on the deployed air bag module and pre-tensioner seat belt.
• The deployed air bag module or pre-tensioner seat belt may contain deposits of sodium
hydroxide, a caustic byproduct of the gas-generated combustion. If this substance gets into your
eyes or on your hands, it can cause irritation and itching. When handling the deployed air bag
module and pre-tensioner seat belt, wear gloves and safety glasses.
• Due to the adoption of 2-step deployment control in both the driver and passenger-side air bag
modules, depending on the impact force, it is possible that inflator No.2 might not operate
(deploy). Before disposing of the air bag module, always follow the inflator deployment
procedures and verify the complete operation (deployment) of inflators No.1 and 2.
08-10–30
AIR BAG SYSTEM
49 H066 002
49 H066 002
49 L066 002
ACTIVATION
SWITCH
acxuuw00001276
acxuuw00001293
acxuuw00001267
id081000801200