Mazda CX-7 2007 Workshop Manual page 1054

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
3. Using a tape-wrapped flathead screwdriver,
remove the oil seal from the oil pump body.
4. Using the SST and a hammer, install the oil seal
to the oil pump body.
Substitution SST
• 49 U027 003
Outer diameter: 67 mm {2.64 in} or more
Inner diameter: 54— 61 mm {2.13— 2.40 in}
Plate thickness: 2 mm {0.08 in} or more
5. Coat the lip of the oil seal with grease.
6. Install the torque converter. (See 05-17-46
TORQUE CONVERTER REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
7. Install the transaxle. (See 05-17-29 AUTOMATIC
TRANSAXLE REMOVAL/INSTALLATION[AW6A-
EL, AW6AX-EL].)
8. Perform the mechanical system test. (See 05-17-3 MECHANICAL SYSTEM TEST[AW6A-EL, AW6AX-EL].)
End Of Sie
TORQUE CONVERTER REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL]
1. Remove the transaxle. (See 05-17-29 AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION[AW6A-EL,
AW6AX-EL].)
Caution
• The oil seal is easily damaged by the sharp edges of the torque converter splines. Do not let the
splines contact the oil seal.
• Do not drop the torque converter.
• Do not pinch fingers.
2. Remove the torque converter, and immediately
turn it so that the hole faces upward. This will help
to keep any remaining fluid from spilling.
3. Drain any ATF remaining in the torque converter.
4. Using a flathead screwdriver, position the drive
gear on the oil pump component in the center.
5. Install the torque converter to the transaxle.
05-17–46
49 U027 003
acxuuw00000605
-0.2—0.2 mm
{-0.00788—0.00788 in}
acxuuw00000606
id051723800700
ampjjw00002212