Mazda CX-7 2007 Workshop Manual page 1057

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
Radiator (In Tank Oil Cooler) Installation Note
1. The automatic transaxle oil cooler flushing must be performed whenever a transaxle is removed for service
because the existing fluid may be contaminated, and to prevent contamination of new fluid.
Note
• Flushing must be performed after installation of an overhauled or replaced transaxle.
2. Follow the instructions in the manufacturer's publication for flushing operation.
Oil Pipe, Hose Clamp, Oil Hose Installation Note
1. Apply compressed air to the cooler-side opening,
and blow any remaining grime and foreign
material from the cooler pipes. Compressed air
should be applied for no less than 1 min.
2. Align the marks, and slide the oil hose onto the oil
pipe until it is fully seated as shown in the figure.
Note
• If reusing the hose, install the new hose
clamp exactly on the mark left by the
previous hose camp.
3. Install the new hose clamp onto the hose.
HOSE CLAMP A
MARK
OIL PIPE
OIL HOSE
HOSE CLAMP C
OIL PIPE
OIL HOSE
MARK
MARK
OIL PIPE
OIL HOSE
HOSE CLAMP B
°
45
70
05-17
acxuuw00000609
acxuuw00000610
°
90
MARK
MARK
°
°
70
acxuuw00002342
05-17–49