Mazda CX-7 2007 Workshop Manual page 1192

8. Remove the duct (2).
9. Remove in the order indicated in the table.
1 Air mix actuator connector
2 Air mix actuator
10. Install in the duct (2).
11. Install the two outer screws, securing the duct (2)
to the A/C unit.
12. Install the screw on the end of the phillips
screwdriver with the packing tape.
Caution
• If the packing tape remains in the duct
(2), it may become a source of noise.
Wind up the packing tape to prevent
pinching when tightening the screw.
13. Install the duct (2) to the A/C unit by inserting a
phillips screwdriver, with the screw, into the hole
made after removing the blower motor.
14. Pull out the Phillips screwdriver together with the
packing tape.
15. Install in the reverse order of removal.
End Of Sie
07-40–20
CONTROL SYSTEM
DUCT (2)
SCREW
SCREW
PHILLIPS
SCREWDRIVER
INSTALLATION
HOLE OF THE
BLOWER MOTOR
SCREW
SCREW
acxuuw00000738
acxuuw00000739
PACKING TAPE
acxuuw00000740