Mazda CX-7 2007 Workshop Manual page 1216

2007 mazda cx-7
Hide thumbs Also See for CX-7 2007:
Table of Contents

Advertisement

DTC B1146, B1147
B1146
Passenger-side side air bag sensor No. 2 system internal circuit disabled
DTC
B1147
Passenger-side side air bag sensor No. 2 system communication error
Warning
• Detection conditions are for understanding the DTC outline before performing an inspection.
Performing an inspection according to only the detection conditions may cause injury due to
an operating error, or damage the system. When performing an inspection, always follow the
DETECTION
inspection procedure.
CONDITION
• Malfunction in wiring harness between passenger-side side air bag sensor No. 2 and SAS control
module
• Malfunction in passenger-side side air bag sensor No. 2 circuit
• Open or short circuit in wiring harness between passenger-side side air bag sensor No. 2 and SAS
POSSIBLE
control module
• Passenger-side side air bag sensor No. 2 malfunction (Including incorrect assembly)
CAUSE
• SAS control module malfunction
SAS CONTROL MODULE WIRING
HARNESS-SIDE CONNECTOR
*
*
3W
3T
3X
3U
Diagnostic procedure
STEP
1
INSPECT PASSENGER-SIDE SIDE AIR BAG
SENSOR NO. 2 CONNECTOR
Warning
• Handling the air bag system
components improperly can
accidentally deploy the air bag
modules and pre-tensioner seat belts,
which may seriously injure you. Read
the service warnings and cautions
before handling the air bag system
components.
(See 08-10-3 AIR BAG SYSTEM
SERVICE WARNINGS.)
(See 08-10-5 AIR BAG SYSTEM
SERVICE CAUTIONS.)
• Turn the ignition switch to the LOCK position.
• Disconnect the negative battery cable and
wait for 1 min or more.
• Remove the trunk side trim (passenger-side).
(See 09-17-24 TRUNK SIDE TRIM
REMOVAL/INSTALLATION.)
• Disconnect the passenger-side side air bag
sensor No. 2 connector.
• Is there any malfunction of the passenger-
side side air bag sensor No. 2 connector?
08-02–14
ON-BOARD DIAGNOSTIC
*
*
*
*
*
*
*
*
*
*
*
*
INSPECTION
PASSENGER-SIDE SIDE AIR BAG SENSOR NO. 2
WIRING HARNESS-SIDE CONNECTOR
B
A
Yes
Replace the air bag wiring harness.
No
Go to the next step.
id080200809900
ACTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents