Mazda CX-7 2007 Workshop Manual page 1251

DTC B2867
DTC B2867 Poor connection of any SAS control module connectors
Warning
• Detection conditions are for understanding the DTC outline before performing an inspection.
Performing an inspection according to only the detection conditions may cause injury due to
DETECTION
an operating error, or damage the system. When performing an inspection, always follow the
CONDITION
inspection procedure.
• There is no continuity between the poor connection detector bar terminals of the SAS control module.
• Poor connection of any SAS control module connectors
POSSIBLE
• Malfunction of any SAS control module connectors
CAUSE
• SAS control module malfunction
1V 1S 1P 1M 1J
1W 1T 1Q
1X 1U 1R
Diagnostic procedure
STEP
1 VERIFY THAT ALL SAS CONTROL MODULE
CONNECTORS ARE CONNECTED WITH SAS
CONTROL MODULE
Warning
• Handling the air bag system
components improperly can
accidentally deploy the air bag
modules and pre-tensioner seat belts,
which may seriously injure you. Read
the service warnings and cautions
before handling the air bag system
components.
(See 08-10-3 AIR BAG SYSTEM
SERVICE WARNINGS.)
(See 08-10-5 AIR BAG SYSTEM
SERVICE CAUTIONS.)
• Turn the ignition switch to the LOCK position.
• Disconnect the negative battery cable and
wait for 1 min or more.
• Partially peel back the floor covering.
• Are all SAS control module connectors
securely connected?
ON-BOARD DIAGNOSTIC
SAS CONTROL MODULE WIRING
HARNESS-SIDE CONNECTOR
1G 1D 1A
2Y 2V 2S 2P
1H 1E 1B
2Z 2W 2T
1I 1F 1C
2AA 2X 2U 2R
INSPECTION
2M 2J 2G 2D 2A
* *
2H 2E 2B 3W
3T
2O 2L 2I 2F 2C
3X 3U
Yes Go to the next step.
No Reconnect the connector properly.
id080200803100
* * * * * *
* *
* * * *
ACTION
08-02–49
08-02