Mazda CX-7 2007 Workshop Manual page 1035

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
12. Verify the correct positioning of the TCM and
coupler component.
13. Tighten the TCM mounting bolts.
Tightening torque
19.6— 29.4 N·m {2.0— 2.9 kgf·m, 14.5— 21.6
ft·lbf}
Caution
• Do not use an impact wrench. Hold the
manual shaft lever when removing the
manual shaft nut, or the transaxle may be
damaged.
14. Install the manual shaft lever and the washer.
15. Set the adjustable wrench as shown in the figure
to hold the manual shaft lever, and tighten the
manual shaft nut.
Tightening torque
9.8— 14.7 N·m {100— 142 kgf·cm, 87— 123
in·lbf}
16. Install the clip to the selector cable as shown in
the figure.
17. Shift the selector lever to P position.
18. Turn the manual shaft lever to P position.
19. Connect the selector cable and install the clip.
20. Connect the TCM connector.
21. Install the air cleaner component. (See 01-13-5
INTAKE AIR SYSTEM REMOVAL/
INSTALLATION[L3 WITH TC].)
22. Connect the negative battery cable.
Warning
• If you replace the ATX or TCM, be sure to
initialize the learned values and perform
neutral position learning.
23. Perform the neutral position learning. (See 05-17-
28 Neutral Position Learning.)
MANUAL
SHAFT NUT
WASHER
MANUAL
SHAFT
LEVER
TCM
MANUAL SHAFT LEVER
CLIP
TCM
MANUAL
SHAFT
LEVER
acxuuw00000531
acxuuw00000525
ADJUSTABLE WRENCH
acxuuw00000524
CLIP
acxuuw00000532
SELECTOR
CABLE
acxuuw00000523
05-17–27
05-17