Mazda CX-7 2007 Workshop Manual page 1296

REAR CENTER SEAT BELT REMOVAL/INSTALLATION
Caution
• The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is
removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly.
Therefore, do not disassemble the retractor.
1. Remove the following parts:
(1) A-pillar lower trim (See 09-17-16 A-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
(2) A-pillar trim (See 09-17-15 A-PILLAR TRIM REMOVAL/INSTALLATION.)
(3) Front scuff plate inner (See 09-17-19 FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(4) Rear scuff plate inner (See 09-17-19 REAR SCUFF PLATE REMOVAL/INSTALLATION.)
(5) B-pillar lower trim (See 09-17-16 B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
(6) Front seat belt upper anchor installation bolt (See 08-11-2 FRONT SEAT BELT REMOVAL/
INSTALLATION.)
(7) B-pillar upper trim (See 09-17-16 B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
(8) Rear seat (See 09-13-7 REAR SEAT REMOVAL/INSTALLATION.)
(9) Sub trunk box (See 09-17-25 SUB TRUNK BOX REMOVAL/INSTALLATION.)
(10)Trunk end trim (See 09-17-24 TRUNK END TRIM REMOVAL/INSTALLATION.)
(11)Trunk side trim (See 09-17-24 TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
(12)C-pillar trim (See 09-17-17 C-PILLAR TRIM REMOVAL/INSTALLATION.)
(13)D-pillar trim (See 09-17-18 D-PILLAR TRIM REMOVAL/INSTALLATION.)
(14)Map light (See 09-18-22 MAP LIGHT REMOVAL/INSTALLATION.)
(15)Sunvisor (See 09-17-26 SUNVISOR REMOVAL/INSTALLATION.)
(16)Assist handle (See 09-17-27 ASSIST HANDLE REMOVAL/INSTALLATION.)
(17)Headliner (See 09-17-27 HEADLINER REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
1 Bolt
2 Rear center seat belt
3. Install in the reverse order of removal.
End Of Sie
WM: SEAT BELT
SEAT BELT INSPECTION
Belt
1. Verify that the belt is installed properly with no twists or kinks.
2. Verify that there is no damage to the seat belt and no deformation of the metal fittings.
• If there is any malfunction, replace the seat belt.
ELR
1. Verify that the belt can be pulled out smoothly,
and that it retracts smoothly.
• If there is any malfunction, replace the seat
belt.
2. Verify that the retractor locks when the belt is
pulled quickly.
• If there is any malfunction, replace the seat
belt.
3. Remove the retractor.
08-11–4
SEAT BELT
id081100800900
38.3—78.4
{3.90—7.99,
28.3—57.8}
N·m {kgf·m, ft·lbf}
acxuuw00001031
id081100800300
acxuuw00002083