Mazda CX-7 2007 Workshop Manual page 1154

BASIC SYSTEM LOCATION INDEX
.
1 Blower unit
(See 07-11-9 BLOWER UNIT REMOVAL/
INSTALLATION.)
(See 07-11-11 BLOWER UNIT DISASSEMBLY/
ASSEMBLY.)
2 Air filter
(See 07-11-12 AIR FILTER REMOVAL/
INSTALLATION.)
(See 07-11-12 AIR FILTER INSPECTION.)
3 A/C unit
(See 07-11-2 A/C UNIT REMOVAL/
INSTALLATION.)
(See 07-11-4 A/C UNIT DISASSEMBLY/
ASSEMBLY.)
4 Rear heat duct
(See 07-11-13 REAR HEAT DUCT REMOVAL/
INSTALLATION.)
End Of Sie
A/C UNIT REMOVAL/INSTALLATION
WM: HEATER UNIT
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See 07-10-6 REFRIGERANT RECOVERY.) (See 07-10-2
REFRIGERANT CHARGING.)
3. Drain the engine coolant. (See 01-12-5 ENGINE COOLANT REPLACEMENT[L3 WITH TC].)
4. Remove the following parts:
(1) Console panel (See 09-17-15 CONSOLE PANEL REMOVAL/INSTALLATION.)
(2) Console (See 09-17-13 CONSOLE REMOVAL/INSTALLATION.)
(3) Front scuff plate inner (See 09-17-19 FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(4) Front side trim (See 09-17-18 FRONT SIDE TRIM REMOVAL/INSTALLATION.)
(5) Dashboard under cover
(6) Glove compartment (See 09-17-8 GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
(7) Hood release lever (See 09-14-25 HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION.)
(8) Lower panel (See 09-17-9 LOWER PANEL REMOVAL/INSTALLATION.)
(9) Center panel (See 09-17-8 CENTER PANEL REMOVAL/INSTALLATION.)
(10)Audio unit (See 09-20-4 AUDIO UNIT REMOVAL/INSTALLATION.)
07-11–2
BASIC SYSTEM
1
9
8
5
7
6
2
3
4
5 A/C compressor
(See 07-11-13 A/C COMPRESSOR REMOVAL/
INSTALLATION.)
6 Condenser
(See 07-11-17 CONDENSER REMOVAL/
INSTALLATION.)
(See 07-11-18 CONDENSER INSPECTION.)
7 Receiver/drier
(See 07-11-19 RECEIVER/DRIER REMOVAL/
INSTALLATION.)
8 Heater hose
9 Refrigerant lines
(See 07-11-15 REFRIGERANT LINES REMOVAL/
INSTALLATION.)
id071100800100
acxuuw00000688
id071100800200