Mazda CX-7 2007 Workshop Manual page 1291

1. Remove the deployed air bag module or pre-tensioner seat belt.
2. Put the air bag module or pre-tensioner seat belt
in a plastic bag, seal the bag, and then dispose of
it.
End Of Sie
WM: DEPLOYMENT TOOL
INSPECTION OF SST (DEPLOYMENT TOOL)
1. Before using the SST (49 H066 002), inspect its
operation.
Inspection Procedure
1. Follow the steps below to inspect the SST (49 H066 002).
• If not as indicated in the table, replace the SST (49 H066 002) because it has a malfunction.
Warning
• Do not use a malfunctioning SST (49 H066 002), otherwise it could cause the air bag module or
pre-tensioner seat belt to accidentally operate (deploy).
Caution
• Because the permissible voltage for the SST (49 H066 002) is 12 V, do not connect a 24 V power
source because it will damage the SST. Always connect only a 12 V power source.
Step Inspection procedure
Connect the power supply
red clip to the positive
1 battery terminal, and the
black clip to the negative
battery terminal.
Connect connectors A and
2
B.
3 Press the activation switch.
End Of Sie
AIR BAG SYSTEM
49 H066 002
CONNECTOR A
Light condition
Green Red
On Off
Off On
BLACK CLIP
On Off
49 H066 002
POWER SUPPLY CLIP
GREEN
LIGHT
CONNECTOR A
acxuuw00002421
id081000801000
CONNECTOR B
ACTIVATION SWITCH
08-10
RED LIGHT
acxuuw00002419
RED CLIP
49 H066 002
ACTIVATION
SWITCH
CONNECTOR B
acxuuw00002420
08-10–31