Mazda CX-7 2007 Workshop Manual page 1245

2007 mazda cx-7
Hide thumbs Also See for CX-7 2007:
Table of Contents

Advertisement

DTC B2445, U2018
B2445
Passenger-side side air bag sensor No.1 (internal circuit abnormal)
DTC
U2018
Passenger-side side air bag sensor No.1 (communication error)
Warning
• Detection conditions are for understanding the DTC outline before performing an inspection.
Performing an inspection according to only the detection conditions may cause injury due to
an operating error, or damage the system. When performing an inspection, always follow the
DETECTION
inspection procedure.
CONDITION
• Malfunction in the wiring harness between the passenger-side side air bag sensor and SAS control
module
• Malfunction in the passenger-side side air bag sensor circuit
• Open or short circuit in the wiring harness between the passenger-side side air bag sensor and SAS
POSSIBLE
control module
• Passenger-side side air bag sensor malfunction
CAUSE
• SAS control module malfunction
SAS CONTROL MODULE WIRING
HARNESS-SIDE CONNECTOR
2Y
2V
2S
2Z
2W
2T
2AA
2X
2U
Diagnostic procedure
STEP
1
INSPECT PASSENGER-SIDE SIDE AIR BAG
SENSOR NO. 1 CONNECTOR
Warning
• Handling the air bag system
components improperly can
accidentally deploy the air bag
modules and pre-tensioner seat belts,
which may seriously injure you. Read
the service warnings and cautions
before handling the air bag system
components.
(See 08-10-3 AIR BAG SYSTEM
SERVICE WARNINGS.)
(See 08-10-5 AIR BAG SYSTEM
SERVICE CAUTIONS.)
• Turn the ignition switch to the LOCK position.
• Disconnect the negative battery cable and
wait for 1 min or more.
• Remove the B-pillar lower trim (passenger-
side).
(See 09-17-16 B-PILLAR LOWER TRIM
REMOVAL/INSTALLATION.)
• Disconnect the passenger-side side air bag
sensor No. 1 connector.
• Is there any malfunction of the passenger-
side side air bag sensor No. 1 connector?
ON-BOARD DIAGNOSTIC
2P
2M
2J
2G
2D
2A
2H
2E
2B
2R
2O
2L
2I
2F
2C
INSPECTION
PASSENGER-SIDE SIDE AIR BAG SENSOR NO.1
WIRING HARNESS-SIDE CONNECTOR
B
A
Yes
Replace the air bag wiring harness.
No
Go to the next step.
id080200802800
ACTION
08-02–43
08-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents