Mazda CX-7 2007 Workshop Manual page 1295

Connector Removal Note
1. Using a flathead screwdriver, pry out the
connector stopper plate.
2. Disconnect the connector.
End Of Sie
ADJUSTER ANCHOR REMOVAL/INSTALLATION
Warning
• The side air bag sensor is attached to the lower part of the B-pillar. When working around the B-
pillar, disconnect the negative battery cable or work carefully, avoiding excessive impact to the
lower part of the B-pillar.
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable.
3. Remove the following parts:
(1) Front seat belt upper anchor installation bolt (See 08-11-2 FRONT SEAT BELT REMOVAL/
INSTALLATION.)
(2) Front scuff plate inner (See 09-17-19 FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(3) Rear scuff plate inner (See 09-17-19 REAR SCUFF PLATE REMOVAL/INSTALLATION.)
(4) B-pillar lower trim (See 09-17-16 B-PILLAR LOWER TRIM REMOVAL/INSTALLATION.)
(5) B-pillar upper trim (See 09-17-16 B-PILLAR UPPER TRIM REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
1 Bolt
2 Adjuster anchor
5. Install in the reverse order of removal.
End Of Sie
WM: REAR SEAT BELT
REAR SEAT BELT REMOVAL/INSTALLATION
Note
• Rear seat belts are built into the rear seat back. See rear seat disassembly/assembly to removal/
installation the rear seat belt. (See 09-13-8 REAR SEAT DISASSEMBLY/ASSEMBLY.)
End Of Sie
SEAT BELT
PRE-TENSIONER
SEAT BELT
CONNECTOR
.
STOPPER
PLATE
acxuuw00001027
id081100802000
1
38.2—78.4
{3.90—7.99,
28.2—57.8}
2
1
38.2—78.4
{3.90—7.99,
28.2—57.8}
N·m {kgf·m, ft·lbf}
acxuuw00002087
id081100800800
08-11–3
08-11