AUTOMATIC TRANSAXLE SHIFT MECHANISM
SHIFT-LOCK INSPECTION
1. Turn the ignition switch to the ON position.
2. Verify that the selector lever is in the P position.
3. Verify that the selector lever cannot be shifted from the P position without depressing the brake pedal.
4. Depress the brake pedal and verify that the selector lever cannot be shifted from the P position.
• If there is any malfunction, inspect the interlock cable.
(See 05-18-2 INTERLOCK CABLE INSPECTION.)
End Of Sie
KEY INTERLOCK INSPECTION
WM: KEY INTERLOCK SYSTEM
1. Verify that the ignition key cannot be pulled out except in the P position.
• If there is any malfunction, inspect the interlock cable. (See 05-18-2 INTERLOCK CABLE INSPECTION.)
End Of Sie
INTERLOCK CABLE INSPECTION
1. Turn the ignition switch to the ON position. (Engine off)
2. Remove the clip of the selector lever base plate,
then remove the interlock cable from the U-
groove.
3. Remove the interlock cable from the selector
lever.
4. Verify that the interlock cable moves freely with
the brake pedal depressed.
• If there is any malfunction, inspect the
interlock cable for abnormal winding. If any
abnormal winding found, correct it.
• If the malfunction persists after correcting the
interlock cable winding, replace it.
End Of Sie
INTERLOCK CABLE ADJUSTMENT
1. Turn the ignition switch to the ON position. (Engine off)
2. Pull up the lock piece of the interlock cable to
release the lock.
05-18–2
INTERLOCK
CABLE
INTERLOCK CABLE
LOCK PIECE
INTERLOCK CABLE
UNLOCK
id051800800400
id051800800100
id051800800200
CLIP
acxuuw00000400
acxuuw00000401
id051800800300
LOCK
acxuuw00000402