Assembling Your Keyset - Samsung OfficeServ SMT-i5243 User Manual

KEYSET DAUGHTER MODULES
[28 AND 18 BUTTON KEYSETS ONLY]
iDCS 28D and 18D button keysets can have one of three different types of daugh-
ter module installed on them to enhance the operation of the keyset or to provide
an additional local port depending on the type of module.
iDCS KDB-DIGITAL LINE INTERFACE
(FKDBD)
[NOT SUPPORTED ON OS 7030, OS 7100, 7200-S]
If your keyset is connected to a Digital Line Interface (DLI) port that supports 2B+D
operation (your installing company can determine this) you may install a daugh-
ter module that provides a Digital Line Interface (DLI) port for connection of a dig-
ital station device such as a keyset or 64 button module.
iDCS KDB-SINGLE LINE INTERFACE
(FKDBS)
[NOT SUPPORTED ON OS 7030, OS 7100, 7200-S]
If your keyset is connected to a Digital Line Interface (DLI) port that supports 2B+D
operation (your installing company can determine this) you may install a daugh-
ter module that provides a Single Line Interface (SLI) port for connection of a stan-
dard telephone device such as a cordless phone. [NOT SUPPORTED ON OfficeServ
7030, OfficeServ 7100 or OfficeServ 7200-S]
10

ASSEMBLING YOUR KEYSET

• Place the keyset face down on a flat surface.
• Remove the base pedestal by placing your thumbs over the attachment clips
and press outward while simultaneously pressing down on the keyset body
with your fingertips.
• Plug the handset cord into the jack marked with the
• Route the handset cord out the RIGHT side of the keyset as you look at it face
down.
• Reattach the base pedestal.
• Plug the line cord into the jack on the base of the keyset marked with the
symbol and route it through one of the cable channels in the bottom
of the base pedestal.
Home Page
symbol.
11