Samsung OfficeServ SMT-i5243 User Manual page 369

Check if there is any currently saved subnet mask address of the phone on the
LCD. If the subnet mask address has not been set, the display will show nothing.
Press any dial buttons from [0]-[9] and [,] button to enter the subnet mask IP
address and then save that subnet mask IP address by pressing the [Enter] button
of navigation button assembly.
• If the [4. GATEWAY SET UP] menu is
selected, press ENTER, the LCD will dis-
play the following message and the user
can enter a new gateway address.
Check if there is any currently saved Gateway IP address of the phone on the LCD.
If the gateway IP address has not been set, the LCD displays nothing.The user can
enter the gateway IP address by using [0]-[9] and [,] button and can save that IP
address by pressing the [ENTER] button of the navigation button assembly.
NOTE: In the [3. NETWORK SET UP MENU], [1. NETWORK MODE SETUP] option,
when [2. DHCP] is selected the IP address, Netmask, and Gateway will not be dis-
played on the LCD.
Load and Upgrade Set/Modify
The fourth item [4. LOAD & UPGRADE SET UP] sets or modifies the IP phone's
software version. Use extreme caution when upgrading the keyset.
Select the [4. LOAD & UPGRADE SET UP] item and move to the lower level. The
screen below is displayed.
1.UPGRADE TFTP SERVER
2.UPGRADE START
Select option [1. UPGRADE TFTP SERVER] and enter the IP address of the TFTP
server containing the ITP software. Use [0]-[9] and [,] button to enter the IP
address. Press ENTER to save.
Select option [2. UPGRADE START] to start the upgrade process.
14
INPUT GATEWAY & PRESS OK
xxx.xxx.xxx.xxx
System Server Setup
The fifth item [5. SYSTEM SERVER SET UP] sets or modifies settings related to
registering the phone to the main processor. You can obtain this information from
your system administrator. The screen below is displayed.
1.SERVER IP ADDRESS
You can set/modify the IP address of the main processor at the [1. SERVER IP
ADDRESS] item. The screen below is displayed when you enter the item. The serv-
er IP is the IP address of the main processor.
INPUT SERVER IP ADDRESS
xxx.xxx.xxx.xxx
You can confirm the current IP address of the main processor at the LCD panel.
The address is left blank if it is not set. Use the dial buttons from [0]-[9], and [,] to
set the IP address and press the [ENTER] button among the navigation buttons to
save and exit. Select the [2. SERVER ID] item.
INPUT SYSTEM ID
You must input the ID assigned to your ITP phone. See your phone system admin-
istrator to get this value. Press the [ENTER] button to save and exit. Select the [3.
SERVER PASS] item.
INPUT SYSTEM PASSWORD
You must input the password associated with your ID. See your phone system
administrator to get this value. Press the [ENTER] button to save and exit.
Completion of Settings
From the main menu, select the seventh item [7. REBOOT] to save all modified
settings and reboot the ITP-5121D phone.
Home Page
15