D About The 5 Mhz Frequency Band Operation (Only Usa Version) - Icom i9100 Instruction Manual

D About the 5 MHz frequency band operation (only USA version)

Operation on the 5 MHz band is allowed on 5 discrete
frequencies and must adhere to the following:
• The USB mode
• Maximum of 50 watts ERP
• 2.8 kHz bandwidth
It's your responsibility to set all controls so that trans-
mission in this band meets the stringent conditions
under which amateur operations may use these fre-
quencies.
NOTE: We recommend that you store these fre-
quencies, mode and filter settings into memory
channels for easy recall.
* The FCC specifies center frequencies on the
5 MHz band. However, the IC-9100 displays carrier
frequency. Therefore, tune the transceiver to
1.5 kHz below the specified FCC channel center
frequency.
(Effective Radiated Power)
BASIC OPERATION
IC-9100 Displayed
Frequency*
5.33050 MHz
5.34650 MHz
5.36650 MHz
5.37150 MHz
5.40350 MHz
To assist you in operating the 5 MHz band within the
rules specified by the FCC, transmission is illegal on
any 5 MHz band frequency other than the five fre-
quencies shown in the table above.
3
FCC Channel
Center Frequency*
5.33200 MHz
5.34800 MHz
5.36800 MHz
5.37300 MHz
5.40500 MHz
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
40