Panel Description; Front Panel - Icom i9100 Instruction Manual

1

PANEL DESCRIPTION

■ Front panel

q
w
e
r
t
y
u
i
q POWER SWITCH [POWER] (p. 31)
➥ Push to turn ON the transceiver power.
• First, confirm the DC power source is turned ON.
➥ Hold down for 1 second to turn OFF the power.
w TRANSMIT SWITCH [TRANSMIT] (p. 46)
Push to select transmit or receive.
• While transmitting, the MAIN Band's TX/RX indica-
tor (i) lights red. Only on the satellite mode, the SUB
Band's TX/RX indicator (!6 ) lights red.
• While receiving or when the squelch opens, the indica-
tor lights green.
e ANTENNA TUNER SWITCH [TUNER] (p. 159)
(Frequency band: HF/50 MHz)
➥ Push to turn the internal antenna tuner ON or
OFF (bypass).
• "
" appears when the tuner is turned ON.
• The internal antenna tuner settings can be memo-
rized in each frequency band.
➥ Hold down for 1 second to manually start the an-
tenna tuner.
• If the tuner cannot tune the antenna within 20 sec-
onds, the tuning circuit is automatically bypassed.
r ANTENNA•METER SWITCH [ANT•METER]
ANTENNA SWITCH Operation (p. 158)
(Frequency band: HF/50 MHz)
➥ Push to select either the ANT1 or ANT2 connec-
tor.
METER SWITCH Operation (p. 45)
(Frequency band: ALL)
➥ Hold down for 1 second to toggle the transmit
meter function between ALC, COMP and SWR.
1
!2 !1
o !0
t HEADPHONE JACK [PHONES]
Plug in standard stereo headphones (impedance: 8
ø
to 16 ).
• Output power: More than 5 mW with an 8 ø load.
• When headphones are connected, the internal speaker,
and any external speaker, are disabled.
• The MAIN and SUB Band audio can be mixed or sepa-
rated when using stereo headphones, depending on the
"Phone Separate" option in the Set mode. (p. 166)
y ELECTRONIC KEYER JACK [ELEC-KEY]
Plug in a bug or paddle type key to use the internal
electronic keyer for CW operation. (p. 22)
• Set the keyer type to ELEC-KEY, BUG KEY or Straight
key in the "Keyer Type" item of the Keyer Set mode.
• When a straight key is connected, "Straight key" must
be selected in the "Keyer Type" item of the Keyer Set
mode. (p. 55)
• A straight key jack is located on the rear panel. See
[KEY] on pages 11 and 22.
• You can reverse the keyer paddle polarity (dot and
dash) in the "Paddle Polarity" item of the Keyer Set mode.
(p. 55)
• Four keyer memory channels are available for your con-
venience. (p. 51)
u MICROPHONE CONNECTOR [MIC]
Plug in the supplied or an optional microphone.
• See page 199 for appropriate microphones.
• See page 30 for microphone connector information.
i MAIN BAND TX/RX INDICATOR
➥ Lights green when the squelch opens, or a signal
is received on the MAIN Band; lights red during
transmit.
➥ Blinks green when an off-frequency signal is re-
ceived, depending on the "FM/DV Center Error"
option in the Set mode. (p. 162)
(dot)
(com)
(dash)