Stapler/Folding Drive Unit - Konica Minolta bizhub C250 Service Manual

Field Service Ver. 1.0 Jul. 2005
[16]
2.3.16

Stapler/Folding Drive Unit

[1]
[5]
[4]
[5]
[3]
[8]
[17]
4583fs2565c0
[18]
4583fs2566c0
[2]
4583fs2567c0
[6]
[5]
4583fs2568c0
[7]
4583fs2569c0
8. Remove the Exit Roller (Lower) [16]
and two Paper Exit Belts [17].
NOTE
• When installing, align the edge of
claws of the Paper Exit Belt [18].
1. Remove the Rear Cover.
☞ 7
2. Open the Front Door [1], and slightly
pull out the stapler section [2].
3. Remove screw [3], and remove the
interface cable presser [4].
4. Remove the Harness from seven
Harness Saddles[5].
5. Remove the Harness from the Wire
Saddle, and disconnect two connec-
tors [6].
6. Remove the Harness from the Har-
ness Saddle, and disconnect the
connector [7].
7. Remove the Harness from the Wire
Saddle, and disconnect two connec-
tors [8].
2. Other
17