Adjustment/Setting; Checking The Image Controller Setting - Konica Minolta bizhub C250 Service Manual

Hide thumbs Also See for bizhub C250:

Table of Contents

Field Service Ver. 1.0 Jul. 2005

Adjustment/Setting

• Whenever the controller is mounted, it is necessary to select "Controller 0" in [Image

Controller Setting].

1. Call the Service Mode to the screen.

2. Touch [System 2].

3. Check that "Controller 0" is selected in [Image Controller Setting].

• If the setting is changed, be sure to turn OFF the Main Power Switch and turn it ON

again more than 10 seconds after. The change of the setting becomes valid when

the Main Power Switch is turned OFF and ON after the appropriate change has

been made on the panel.

A. Note on returning the setting from "Controller 1" to "Controller 0."

• Selecting "Controller 0" will initialize the following settings made while "Controller 1" was

selected. Reset the following items as necessary when using the Internal Standard Con-

• Setting items included in [Network Setting] available from [Administrator Setting].

(Except [Status Notification Setting] and [Prefix/Suffix Setting] available from the follow-

ing setting. [Administrator Setting] - [Network Setting] - [Detail Setting].)

• [Administrator Setting]-[User Authentication/Account Track]-[General Settings]-[External

• [Administrator Setting]-[System Connection]-[IS OpenAPI Setting]

4. Checking the Image Controller Setting

Table of Contents