Konica Minolta bizhub C250 Service Manual page 742

Field Service Ver. 1.0 Jul. 2005
ON
1 2 3 4
NOTE
• The procedure must be carried out as specified. In particular, switching ON or OFF
must be performed properly.
• If a step or steps are wrongly performed in mid procedure, stop the procedure
immediately. Then turn OFF the Main Power Switch of the main unit, wait for 10
sec. or more, and turn ON the Main Power Switch. After performing these steps,
start the procedure over.
• This adjustment is applicable only to the punch position center adjustment. The
adjustment range is ± 5 mm. It does not adjust for variations in the punch hole
positions.
5 6 7 8
4583fs3530c0
16. Turn ON key 7 of SW1 of the Fin-
isher Control Board.
NOTE
• Flipping ON key 7 of SW1 validates
the setting made to the fixed sys-
tem based on the paper size as
changed from the lateral registra-
tion motion (automatic through end
face detection).
• To return the setting back to the lat-
eral registration motion, flip OFF
key 7 of SW1.
17. Turn ON the Main Power Switch of
the main unit.
18. Reinstall the rear cover.
☞ 7
6. Board switch
49