Konica Minolta bizhub C250 Service Manual page 75

3. Periodical check
[5]
[4]
B. Reinstallation Procedure
[1]
32
[4]
4038F2C025DA
4038F2C026DA
[2]
4038F2C027DA
Field Service Ver. 1.0 Jul. 2005
7. Hold the position [4] as shown in the
left and remove the Image Transfer
Belt Unit [5].
NOTE
• Do not touch the surface of the
Image Transfer Belt Unit.
• Cover the Image Transfer Belt Unit
with something such shade cloth to
protect its surface from dust or for-
eign matter.
1. Insert the Transfer Belt Unit [1].
NOTE
• Insert the Transfer Belt Unit with
care not to allow its docking gear to
be damaged by hitting it against the
rail or associated part.
• Do not touch the surface of the
Image Transfer Belt Unit.
• Cover the Image Transfer Belt Unit
with something such shade cloth to
protect its surface from dust or for-
eign matter.
2. Install the Image Transfer Belt Unit
with two Screws [2].
NOTE
• Replace the 2nd Image Transfer
Roller, the Ozone Filter and the
Dust Filter/Vertical Conveyance,
which are supplied with the Image
Transfer Belt Unit, at the same time.
3. Close the Right Door.
4. Reinstall the Imaging Unit and the
Waste Toner Box.
5. Turn ON the Main Power Switch.
6. Close the Front Door.
7. Select [Service Mode] → [Imaging
Process Adjustment] → [Gradation
Adjust] and carry out Gradation
Adjust.