Konica Minolta bizhub C250 Service Manual page 152

Field Service Ver. 1.0 Jul. 2005
[12]
[14]
[17]
[18]
[19]
[21]
[22]
[13]
[11]
0.3 mm
4038F2C549DA
[15]
[15]
[14]
4036fs2564c0
[16]
4036fs2584c0
[20]
[23]
4036fs2565c0
10. Mount the Scanner drive gear [11]
on the shaft [12] and secure it using
the screw [13].
NOTE
• Allow a clearance of about 0.3 mm
between the Scanner drive gear and
bushing.
• Apply the Screw lock on the Screw.
11. Secure the front and rear pulleys [14]
using the screw [15] each.
NOTE
• Apply the Screw lock on the Screw.
NOTE
• Mount the Screw [16] in the direc-
tion that is opposite against the
direction for which Scanner Drive
Gear [17] and Screw [18] are
screwed together as shown in the
left figure.
12. Mount the Scanner Motor Assy.
☞ 100
<Front>
13. Wind the bead end of the cable [19]
around pulley C [20] and pulley B
[21], then hook the bead [22] onto
the Adjustable Anchor [23].
6. Other
109