Faults With Document Handling - Olivetti PR2 PLUS Service Manual

Faults with document handling

Fault
X X X X
X X X X
X X X
X X
X
X
X X
X
X
X
X
XZAC4219-05
Possible cause Solution
Check the dimensions and the type of the document . See
Document not acc.
"DOCUMENTS THAT CAN BE HANDLED BY THE BASIC
to specs
MACHINE" on page 1 - 3
Document ruined Use another document.
Closing levers open Lower the lever for closure.
1
Front
photosensors
2
fault
1
2
Paper
photosensor
fault
3
Replace the services motor. See the section
Service motor fault
motor disassembly/reassembly" on page 7 - 14
Paper feed Replace the paper feed motor. See
motor fault disassembly/reassembly" on page 7 - 12
Adjustment of needle
See
roller incorrect
See
Print bar not adjusted
on page 6 - 4
correctly
absent)" on page 6 - 5
Adjust the printing band. See
parallelism and leaf spring load on the basic machine" on
Band not adjusted
page 6 - 6
torsion bar)" on page 6 - 7
Roller gears not Adjust the gears. See
adjusted page 6 - 9
Service Manual
Carry out the calibration procedure. See the section
"CALIBRATING THE PHOTOSENSORS" on page 4 -
18
Clean and if necessary replace the fault photosensor.
See "PROCEDURE FOR CLEANING / REPLACING
THE PHOTOSENSORS" on page 6 - 2
Adjust the sensor position. See the section
Paper Photosensor" on page 6 - 8
Carry out the calibration procedure. See
"CALIBRATING THE PHOTOSENSORS" on page 4 -
18
Clean and if necessary replace the fault photosensor.
See "PROCEDURE FOR CLEANING / REPLACING
THE PHOTOSENSORS" on page 6 - 2
"Adjusting the roller gears" on page 6 - 9
"Adjusting the print bar (where torsion bar present)"
or "Adjusting the print bar (where torsion bar
or "Adjusting parallelism of print bar (without
"Adjusting the roller gears" on
"Adjusting
"Services
"Paper feed motor
"Adjusting the print bar
5-19