7. Back off the two lock-screws (9) of the photosensor support (10) and remove it.
9
Printers with torsion bar
Figure 7 - 21 Removing the photosensor support
NOTE: during reassembly, do not fix the photosensor support until the feeder unit is fixed, as the feeder
unit has two reference pins for the photosensor support. During the reassembly phase, you must
adjust the front pressure rollers.
See the section
At the end of these operations, carry out calibration of the photosensors. See the section
"CALIBRATING THE PHOTOSENSORS" on page 4 -
XZAC4219-05
10
9
"Adjusting the front pressure rollers" on page 6 -
Service Manual
9
10
Printers without torsion bar
10.
18.
9
7-17