Display Messages; Power On Messages - Olivetti PR2 PLUS Service Manual

DISPLAY MESSAGES

The following table lists the messages of state, warning and error that can be visualized on the display of the
console, when the printer is equipped with alphanumeric display.

Power on messages

MESSAGE
Olivetti
PR2 PLUS
Start Up
COVER OPEN
RS232 Error
ERROR
RFID Time Out
ERROR
SBI Time Out
WARNING
Setup Software
WARNING
Setup Hardware
WARNING
Mainten. Data
ERROR
Characters Gen.
5-8
TIME OUT DESCRIPTION
No timeout Startup message
No timeout Startup condition. Means please close cover for continue.
1 second Serial channel (parity, framing, overrun).
10 seconds RFID module.
SBI (serial BUS vs MICR Option)
• Replace the MICR board. See the section
magnetic/MICR disassembly/reassembly" on page 7 - 28
10 seconds
• Replace the MICR head.
See the section
disassembly/reassembly" on page 7 -
Inconsistency in printer configuration data (programming values)
saved in the dedicated Flash EPROM area. The printer forces the
default values for the firmware release.
• Press any key on the console, when appropriate, to display
No timeout the next anomaly.
• Check if the default values forced by the printer are the correct
ones by printing the configuration data. See the section
"Activating and deactivating the print test" on page 2 - 10
• Proceed with initialisation of the printer.
Inconsistency of calibration values (photosensors, alignments etc).
All the calibration values are initialised with their default values.
• Press any key on the console to display the next anomaly,
when necessary.
• Perform all the printer calibrations. See the section
No timeout
"PROGRAMMING AND CALIBRATION" on page 4 - 1
• Replace the motherboard. See the section
reassembling the motherboard (printers with scanner)
Disassembling/reassembling the motherboard (printers with
serial number 8.xxx.xxx and
Memory Maintenance data area corrupted.
Impossible to recover valid maintenance data from the dedicated
No timeout
Flash EPROM area. The maintenance data will be reinitialised
with the value «0».
Character generator missing or corrupt
No timeout Proceed with forced loading of the firmware and of the character
generator.
Service Manual
"Horizontal magnetic/MICR printhead assy
30.
1.xxx.xxx).
"Horizontal
Disassembling/
or
XZAC4219-05