Modifying Configuration Parameters - Olivetti PR2 PLUS Service Manual

8. To pass to the next menu, press the STATION2 key.
The new menu is printed and you can change the parameters
related to the «IBM» emulation.
9. Pressing the STATION2 key again, you can pass to the third
menu.
10. The new menu is printed and you can change the parameters
related to the «OLIVETTI» emulation.
11. These menus operate in a cyclical fashion therefore, when the STATION2 key is pressed again, you return to
the initial menu «CONFIG.».
12. Therefore, select the menu for which you want to change parameters, and proceed to configure them as
described in the next section.

Modifying configuration parameters

NOTE: the procedure below illustrates the steps to follow to change the configuration parameters.
In this example, the procedure is described for modifying the fifth parameter «INTERFACE» in the
Configuration menu, «CONFIG.». To change the configuration of the other parameters proceed in a
similar way.
NOTE:
1. Enter the Configuration menu following the procedure
described in the previous section. The currently active menu
is printed.
2. Press the STATION1 key.
3. The setting for the first configuration parameter is printed.
4. Let's imagine that we do not want to change this parameter.
Therefore we press the STATION1 key again to pass to the
next parameter.
5. The setting for the second configuration parameter is printed.
4-2
MENU: CONFIG.
STATION1=confirm STATION2=Skip Press Local to continue
MENU: CONFIG.
STATION1=confirm STATION2=Skip Press Local to continue
MENU: CONFIG.
STATION1=confirm STATION2=Skip Press Local to continue
DRAFT SPEED: NORMAL
MENU:
STATION1=confirm STATION2=Skip Press Local to continue
LQ TYPE:
DRAFT SPEED: NORMAL
MENU:
STATION1=confirm STATION2=Skip Press Local to continue
Service Manual
IBM
IBM OLIVETTI
CONFIG.
LQ2
CONFIG.
XZAC4219-05