Olivetti PR2 PLUS Service Manual page 102

Fault
X
X X
5-18
Possible cause
Paper photosensor
X X
not adjusted correctly
Print bar not adjusted
correctly
Wrong configuration
X X
parameters
Document driving
X belt not correctly
adjusted
X Band not adjusted
Roller gears not
X
adjusted
Front pressure rollers
X not adjusted
correctly.
Carriage belt not
X X
calibrated
Rear roller motor not
X X
working
Service Manual
Solution
See "Adjusting Paper Photosensor" on
page 6 - 8
See "Adjusting the roller gears" on page 6
- 9
Reprogram the parameters of the printer.
See "Modifying configuration parameters"
on page 4 - 2
See "Adjusting the document drive belt"
on page 6 - 3
Adjust the printing band. See
the roller gears" on page 6 - 9
Adjust the gears. See "Adjusting the roller
gears" on page 6 - 9
Adjust the pressers of the front rollers.
"Adjusting the front pressure rollers" on
page 6 - 10
Adjust the belt for carriage movement. See
"Replacement and adjustment of belt for
carriage movement" on page 6 - 15
Replace the motor. See "Disassembling/
reassembling pressure roller unit" on
page 7 - 20
"Adjusting
XZAC4219-05