Mechanical Assy Disassembly/Reassembly - Olivetti PR2 PLUS Service Manual

Mechanical assy disassembly/reassembly

1. Disassembling the casing. See the section
2. On both sides, back off the lock-screws (1) of the tabs that fasten the front rubber pads so that these can be
removed from their housing.
Figure 7 - 6 Disassembling the mechanical assy
3. From the front, lift the entire mechanism from the base plate and rotate it partially so as to access the
connectors of the motherboard.
4. Disconnect all the connection cables of the mechanism to the motherboard, except for the motherboard - power
supply unit connection cable.
Printers with serial number 8.xxx.xxx
Figure 7 - 7 Disconnecting the cables
5. Loosen the lock-screws (2) of the tabs that fasten the rear rubber pads so that these can be removed from their
housing.
6. Back off the screw (3) that fastens the ground cables.
7. Lift the mechanical assy and separate it from the base plate.
7-6
"Casing disassembly/reassembly" on page 7 -
1
Service Manual
4.
Printers with serial number 1.xxx.xxx
XZAC4219-05