Olivetti PR2 PLUS Service Manual page 62

If the «INTERFACE» parameter has been configured as SERIAL1
Parameter
RS1 EMULATION
BAUD RATE
BIT/CHAR
PARITY
STOP BIT
DSR
DCD
If the «INTERFACE» parameter has been configured as PARALLEL
Parameter
PAR. EMULATION
PAR. PORT MODE
4-8
Values possible
OLIVETTI *
IBM
9600 *
4800
2400
1200
19200
38400
7
8 *
NONE *
ODD
EVEN
1 *
2
N
Y *
NO *
YES
Values possible
OLIVETTI *
IBM
CX
BIDIRECT.
Service Manual
Description
Default emulation of the port.
Data transmission/reception speed.
Data format at 7 or 8 bits.
This parameter is used to set the presence and type of
parity control (even or odd). By default, parity control is
disabled (none).
Number of stop bits.
Data Set Ready managed or not
Data Carrier Detector managed or not.
Description
This parameter is used to set the emulation type of the
parallel port.
This parameter is used to set the operation mode for
the parallel port.
XZAC4219-05