EPSON AcuLaser C1100
5.1 Overview
This chapter explains the adjustment necessary to maintain the functions and performance of the AcuLaser C1100.
5.1.1 Instructions
Before starting your adjustment work, always check the CAUTION on the right.
Refer to
" 5.1.2 Part/unit-based adjustment items"
C A U T I O N
units in advance.
Start adjustment after fully checking the Caution given in the explanation area of each adjustment item. Incorrect work may interfere with the
product operations and/or functions.
5.1.2 Part/unit-based adjustment items
The following table indicates the adjustment items and life counter clear items necessary when the specific unit is replaced or removed.
Repaired Part
Adjustment Item
FUSER ASSY
Life counter clear
2ND BTR ASSY
Life counter clear
HOUSING ASSY-DEVE Life counter clear
BOARD ASSY., MAIN Writing USB ID
Controller Firmware Update
—
MCU Firmware Update
—
ADJUSTMENT
(p.486), always confirm the adjustment items and the orders for the replaced/removed parts and
Table 5-1. Adjustment Item List
Execution Timing
Execute by the operation panel
After replacement with a new one
(Maintenance Menu [Reset Fuser Counter])
Execute by the operation panel
After replacement with a new one
(Maintenance Menu [Reset 2ndBTRCounter])
Execute by the operation panel
After replacement with a new one
(Maintenance Menu [Reset X DvopCounter])
After replacement with a new one
Execute by the dedicated program
Start the printer by performing special operation [Program ROM
—
update], and send the firmware data from the PC.
Start the printer by performing special operation [Engine program
—
update], and send the firmware data from the PC.
Overview
Adjustment Execution Means
Revision B
Reference
p.497
p.497
p.497
p.487
p.489
p.490
486