Epson AcuLaser C1100 Service Manual page 323

EPSON AcuLaser C1100
REINSTALLATION
1. Slide the actuator of ACTUATOR EMPTY into the clearance of MSI ASSY, slide
the shaft on ACTUATOR EMPTY along the notch on MSI ASSY, and attach
ACTUATOR EMPTY.
2. Insert the right-side shaft of ACTUATOR EMPTY into the hole on MSI ASSY,
and fasten the groove on the left-side shaft of ACTUATOR EMPTY to the hook
on MSI ASSY.
Make sure that ACTUATOR EMPTY is firmly fastened to the
C A U T I O N
hook.
3. Insert the left and right bosses into the notch on MSI ASSY with PLATE
BOTTOM 2 raised 90°, and attach PLATE BOTTOM 2.
4. Insert the holes of PLATE BOTTOM 2 into the boss on PLATE BOTTOM ASSY
MSI while extending the left and right attachment sections of PLATE BOTTOM
2.
5. Attach SENSOR PAPER EMPTY.
6. Attach GUIDE SIDE L and GUIDE ASSY SIDE R.
7. Attach MSI ASSY. (p.304)
8. Attach FRAME ASSY-PH. (p.327)
9. Attach COVER FRONT L and COVER FRONT ASSY U.
10. Attach COVER MSI. (p.291)
11. Attach COVER ASSY LH. (p.295)
12. Attach COVER ASSY RH. (p.301)
DISASSEMBLY AND ASSEMBLY
(p.321)
(p.310)
(p.292)
11)-1
[2)]
CAUTION
12)
Figure 4-39. Removal of ACTUATOR EMPTY (2)
MSI
Revision B
11)-2
Leg_Sec03_053FB
323