EPSON AcuLaser C1100
1.14 Controller Specifications
1.14.1 Controller Basic Specifications
CPU
: VR4305 (66.7 MHz)
Enhanced technology
: CPGI, CRIT, RITech (the ASIC uses HTC)
RAM
: SDRAM
Standard
: 32 MB (mounted on the code ROM DIMM side)
Expansion
: 16 MB, 32 MB, 64 MB, 128 MB, 256 MB
(90pin DIMM)
1 slot, maximum 256 MB
Even if 256 MB memory is installed, available size is not become
C A U T I O N
288 MB because of restriction of ASIC.
Program ROM
: 4 MB Flash (DIMM)
Panel
: LCD 20 digits, 1 line; 3 LEDs; 6 switches
Interface
Standard
•
Parallel
: 1 ch (IEEE1284 compliant bi-directional B-type
connector, Compatibility, Nibble, ECP)
•
USB
: 1 ch (Rev.2.0 HS) (D4 Level 3 supported)
•
Network interface board : 1 slot
There are 2 models, either Network interface board is installed or
C H E C K
P O I N T
not installed.
However, attaching the board to the "not installed model" is
possible.
PRODUCT DESCRIPTION
Printer mode
Standard
Other
Auxiliary software
Installation method
1.14.2 Controller Configuration
The printer can be set with the following configurations according to destination.
R190
Open
Short
Controller Specifications
: ESC/PageS Printing System (ESC/PageS03)
: EJL mode
RCC mode
DCC mode
EpsonNet Config (Web)
: Status sheet
Maintenance mode (engine status sheet)
Update function for mechanical controller firmware
(EFU)
: Fixed to the main body
Table 1-35. Pattern jumper (INPT0)
1
Default for tray paper size: A4
0
Default for tray paper size: LT
Revision B
46