Status Messages And Troubleshooting - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100
Table 1-39. List of Printer Messages
Display
(Job processing)
(communication to non active I/F port)
(test printing)
Warming Up
Calibrating Printer
8
Offline*
3
Cancel Print Job*
uuuu Toner Low
Worn Photoconductor
Worn Fuser
Worn uuuu Dev Unit
NonGenuine Toner
8
Sleep*
8
Ready*
Note *1: W W W W W=C, D, E, F, G, DM, MP, LC
*2: Cancel Print Job and Cancel All Print Job using the operation panel.
*3: Cancel Print Job using the host.
*4: For detailed information on responding to composite errors, refer to the print status
area.
*5: For detailed information on responding to composite errors, refer to the print status
area.
*6: For detailed information on responding to consumable warning status, refer to the
relevant area.
*7: w w w w=A, B, C, D, DM, E, F, G
*8: Toner remaining is added.
Displays the remaining toner, right aligned, in the order of K, C, M, Y in seven
increments.
PRODUCT DESCRIPTION
Error LED
Sort Status code
status
Status 1002
Status 1012
--- --- 1010
Status --- 1006
Status --- 1014
Status --- 1001
Status --- 1003
6
Warning --- 2571*
6
Warning --- 2571*
6
Warning --- 2571*
6
Warning --- 2571*
6
Warning --- 2571*
Status --- 1007
Status --- 1000
Printer Status

1.16.2 Status Messages and Troubleshooting

The following are items specific to this printer.
Please Wait
Explanation
When replace toner is specified from the panel operation or with a command, this
message is displayed while the cartridge moves to the replacement position.
Once it moves to the required position, the message changes to "Replace Toner
X".
Calibrating Printer
Explanation
Indicates that printer (engine) is in the following conditions:
• The process control is in execution.
• Engine is writing the data to the CRUM.
With this printer, this is performed automatically at the following timing.
• When has printed 50 copies (pages) continuously (By stopping the print job
temporarily)
• When has printed 20 copies (pages) intermittently (After finished a current print
job)
• When has printed text or images with high print ratio
• When has printed in black and white continuously
• When detected that the Fuser Assy is cold at power-on
• When Toner Cartridge is replaced after the printer detects the "toner end" status.
• When Photoconductor Unit is replaced with a new one
Revision B
57