Motor Assy Feeder - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.13.14 MOTOR ASSY FEEDER

REMOVAL
1. Remove COVER LEFT 500. (p.453)
2. Unclamp the clamp on DRIVE ASSY FEED, and remove the harness on MOTOR
ASSY FEEDER.
3. Disconnect connector (P/J446) from PWBA MOT.
4. Remove the 2 screws (silver, 6 mm) fastening MOTOR ASSY FEEDER to
DRIVE ASSY FEED.
5. Remove MOTOR ASSY FEEDER from DRIVE ASSY FEED.
REINSTALLATION
When performing the following work, pay attention to the
C A U T I O N
attachment direction of MOTOR ASSY FEEDER.
1. Attach MOTOR ASSY FEEDER to DRIVE ASSY FEED with the harness of
MOTOR ASSY FEEDER facing up.
2. Fasten MOTOR ASSY FEEDER to DRIVE ASSY FEED with the 2 screws
(silver, 6 mm).
3. Connect connector (P/J446) to PWBA MOT.
4. Fasten the harness on MOTOR ASSY FEEDER with the clamp on DRIVE ASSY
FEED.
5. Attach COVER LEFT 500. (p.453)
Connector
Panel Indication Symptom
No.
P/J446 Jam LC, G FEEDER Jam
DISASSEMBLY AND ASSEMBLY
Error Caused by Connector
Disconnection
---
500 PAPER CASSETTE & 500 PAPER FEEDER
5)
4)
2)
4)
Figure 4-160. Removal of MOTOR ASSY FEEDER
Revision B
3)
Leg_Sec03_516EA
460