Solenoid Assy Dup - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.12.7 SOLENOID ASSY DUP

REMOVAL
1. Remove DUPLEX ASSY. (p.412)
2. Remove COVER-R DUP. (p.413)
3. Remove COVER-L DUP. (p.414)
4. Remove LINK-LATCH and LINK-BUTTON.
5. Open COVER UP-DUP TRANS, and remove INVERTER ASSY DUP. Note that
COVER LOW-DUP TRANS and COVER UP-DUP TRANS need not be
removed. (p.417)
6. Remove COVER-INV. (p.415)
7. Disconnect connector (P/J611) from SOLENOID ASSY DUP.
8. Remove the 2 screws (silver, 5mm) fastening SOLENOID ASSY DUP to
INVERTER ASSY DUP.
9. Remove SOLENOID ASSY DUP from INVERTER ASSY DUP.
REINSTALLATION
1. Insert the pin on SOLENOID ASSY DUP into the hole on INVERTER ASSY
DUP, and attach SOLENOID ASSY DUP.
2. Remove the 2 screws (silver, 5mm) fastening SOLENOID ASSY DUP to
INVERTER ASSY DUP.
After connecting the connectors on SOLENOID ASSY DUP, make
C A U T I O N
sure that HARNESS-ASSY DUP1 is firmly hooked on the hook on
FRAME-INV.
DISASSEMBLY AND ASSEMBLY
(p.416)
DUPLEX
9)
7)
8)
8)
Figure 4-122. Removal of SOLENOID ASSY DUP
Revision B
Leg_Sec03_122FA
419