Plate Bias-2Nd Assy - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.5.11 PLATE BIAS-2ND ASSY

REMOVAL
1. Remove COVER ASSY RH. (p.301)
2. Remove CHUTE ASSY-FSR and COVER ASSY-RR 2ND.
3. Remove 2ND BTR ASSY. (p.348)
4. Remove the 2 screws (silver, with flange, tapping, 6 mm) fastening PLATE BIAS-
2ND ASSY to the main unit.
When performing the following work, take care not to remove
C A U T I O N
PLATE BIAS-2ND ASSY too far as it is connected by WIRE ASSY
2BTR.
5. Unclamp the clamp fastening WIRE ASSY 2BTR, and slightly release PLATE
BIAS-2ND ASSY from the main unit.
6. Remove the screw (silver, tapping, 6 mm) fastening the terminal of WIRE ASSY
2BTR to PLATE BIAS-2ND ASSY.
7. Remove WIRE ASSY 2BTR from PLATE BIAS-2ND ASSY, and remove
PLATE BIAS-2ND ASSY.
DISASSEMBLY AND ASSEMBLY
4)
(p.341)
5)-2
TRANSFER
E ring
4)
7)
6)
5)-1
Figure 4-70. Removal of PLATE BIAS-2ND ASSY
Revision B
SHAFT-CENT 2ND
Leg_Sec03_150FB
358