Mot Assy Micro - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.10.7 MOT ASSY MICRO

REMOVAL
1. Remove COVER ASSY LH. (p.295)
2. Unclamp the clamp fastening the harness on MOT ASSY MICRO.
3. Disconnect connector (P/J600) from MOT ASSY MICRO.
4. Remove the 2 screws (silver, with flange, 4mm) fastening MOT ASSY MICRO to
the main unit.
5. Remove MOT ASSY MICRO from the main unit.
REINSTALLATION
When performing the following work, pay attention to the
C A U T I O N
attachment direction of MOT ASSY MICRO.
1. Attach MOT ASSY MICRO to the main unit with the harness on MOT ASSY
MICRO facing the rear side.
2. Fasten MOT ASSY MICRO to the main unit with the 2 screws (silver, with flange,
4mm).
3. Connect connector (P/J600) to MOT ASSY MICRO.
4. Fasten the harness on MOT ASSY MICRO with the clamp.
5. Attach COVER ASSY LH. (p.295)
DISASSEMBLY AND ASSEMBLY
Figure 4-105. Removal of MOT ASSY MICRO
DRIVE
3)
2)
2)
4)
5)
4)
Leg_Sec03_104FA
Revision B
399