Fuser Lock Switch - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.9.2 FUSER LOCK SWITCH

REMOVAL
1. Remove FUSER ASSY. (p.388)
2. Remove COVER ASSY LH. (p.295)
3. Remove CHUTE ASSY-FSR and COVER ASSY-RR 2ND.
When performing the following work, leave the intermediate
C A U T I O N
connector on the harness side.
4. Disconnect the connector (P/J128, blue) from FUSER LOCK SWITCH.
5. Unclamp the two clamps fastening the harness on FUSER LOCK SWITCH to
remove the harness, and put the connector of FUSER LOCK SWITCH to the
inside the main unit from the hole on the main unit.
When performing the following, take care not to damage FUSER
C A U T I O N
LOCK SWITCH by falling or dropping it.
6. Remove the screw (silver, with flange, tapping, 6 mm) fastening FUSER LOCK
SWITCH to the main unit.
7. Slide FUSER LOCK SWITCH to the right, unhook the hook on FUSER LOCK
SWITCH from the hole on the main unit, and remove FUSER LOCK SWITCH.
DISASSEMBLY AND ASSEMBLY
(p.341)
FUSER
5)-1
6)
5)-1
7)
Figure 4-97. Removal of FUSER LOCK SWITCH
Revision B
4)
5)-2
Leg_Sec03_519EA
390